Share:

Firmware  

  RSS

Meek
 Meek
(@manyakim)
Member Admin
Joined: 1 year ago
Posts: 18
01/02/2019 7:29 pm  

Attached you'll find the latest revision (Meek v1.2) of the ESPEasy fimware which is slightly modified for stable operation for the Meek devices.

As this firmware is based on the 2.5beta core, it's advisable to do a full memmory wipe with a serial programmer, and afterwards install this firmware.

 

This topic was modified 5 months ago by Meek

Quote
Meek
 Meek
(@manyakim)
Member Admin
Joined: 1 year ago
Posts: 18
17/04/2019 8:01 pm  

New Stable FW, v1.5.1, based on ESPEasy 20180519:

 

This post was modified 2 months ago 4 times by Meek

ReplyQuote
Meek
 Meek
(@manyakim)
Member Admin
Joined: 1 year ago
Posts: 18
04/05/2019 2:09 pm  

MEEK MP1
Preprogrammed per FW 1.5.1 :
On power On/boot sequence :LED will lit RED for 5 seconds, do not touch the touch button during this period.
Initializing and calibration of the touch will be initiated and afterwards, the LED will lit WHITE.
For the first minutes after boot, depending of your Wi-Fi coverage and LAN environment, the unit might act with a small delay due to Wi-Fi/LAN initialization, network scanning and if applicable, logging/handshake with your Home Automation System.

On boot, Doppler is enabled and actively scanning in near premises of Meek MP1 within +/- 6meters in front of Meek MP1. The LED will lit White.
Once movement detected, the output will be enabled and the timers will be activated for a duration of 70seconds, LED will be PURPLE.
Within this 70 seconds, the Doppler is continuously scanning for movement and if movement is detected, the counter will be reset and countdown for 70sec will continue, LED will lit PURPLE.

If touch button is touched, the Doppler will be disabled, and the Meek MP1 will act as a regular On-Off switch, LED will be RED.

To re-enable the Doppler, touch the button for a duration of 3 seconds, the LED will change color and the Switch will generate a Tone, to acknowledge that the Doppler is activated.


Meek MT1-2-3
Preprogrammed per FW 1.5.1 :
On power On/boot sequence :LED will lit RED for 5 seconds, do not touch the touch button during this period.
Initializing and calibration of the touch will be initiated, afterwards, the LED will lit WHITE.
For the first minutes after boot, depending of your Wi-Fi coverage and LAN environment, the unit might act with a small delay due to Wi-Fi/LAN initialization, network scanning and if applicable, logging/handshake with your Home Automation System.

If touch button is touched, the output will be toggled On/off, the LED will lit WHITE on Off, and PURPLE once output is On.
On button press, the switch will give audio and visual feedback (LED will lit WHITE when output if Off and Purple once output is On.


ReplyQuote
Close Menu
×
×

Cart

  
Working

Please Login or Register